tail servo centering

[rcflier1]

i must be missing something, where do you select 760 or 1520 as the servo center? i am used to the beast x where there is a selection.

[Keyrigger]

Go to Forward Programming, Setup, Tail Rotor, Output Setup and set the Frame Rate. The manual has it covered from there.

Don

[rcflier1]

yep, that did it, thanks. now if i could only get rid of that annoying tail drift while sitting on the bench.

[Keyrigger]

Connect your 6250 to the computer with the 3065 data cable and use the Spektrum Programmer to connect and update your FC. However, you will need to re-level the 6250 after updating the the latest version.

Don

[rcflier1]

yep, did that already, had read about it. no change. still slow drift

[Fusion]

My 3065 used to do that on my Fusion 360 with FC6250HX, but only on the bench. It never had any effect while flying. After I changed to the, in my opinion more reliable, KST ds215mg servos (also for tail) And calibrated I never had the issue anymore.


Sent from my iPhone using Tapatalk

[rcflier1]

update, i finally got a chance to try the calibration. tail drift on the bench gone. thanks.