Swapped VCT now scorpion telemetry not working

[Neckbone1]

I swapped my Vcontrol touch with a buddies vcontrol touch. I had everything perfectly setup and it was easy and painless, but no that I've swapped transmitter my scorpion telemetry info is not showing up on any of heli's. All of these helis have scorpion tribunus esc's and are in working order with telemetry cable and flown ever weekend prior to transmitter swapp.

I have the scorpion app downloaded and active on my vct, it shows up on my screen but shows no info when the model is plugged in. I'm using current firmware. What have I done wrong?

I have bound these heli's and even test flown a couple and everthying works minus the scorpion telemetry.

[Neckbone1]

I figured it out.

[jakeg1999]

Curious of what the issue/fix was? I’m having an unrelated issue where my VCT appears to see the Scorpion Tribunus esc and reads the telemetry, battery may and headspeed. However I cannot get the Vbar gov to work properly. It hits a certain low headspeed and just stays there, no matter what I type in for requested headspeed. Example I type in 1300, 1600, 1900 and I get 1276 for all three. Updated all software and tried everything I can think of. I can switch over to the Scorp gov in the VCT and get my requested headspeeds that way ie 50%, 60%, 80% and it seems to work fine, I just prefer the feel of the Vbar gov. Anyway, not trying to hijack your thread as I could just start one but I’m curious if different things you may have tried to fix your issue.

[tonys-heli]

sounds like you bank switch isnt set up correctly or an app isnt there.