I'll start a new thread. help with vbar and throttle cut or limit? (not a vbar issue)

[JasonA]

So I'm trying to setup my first heli on the MZ-24... got the Vbar software to see it fine but there's this weird arbitrary limit of 14% on ch6 which is the throttle and I cannot for the life of me figure out how or where to change that.

I made a vid... any help would be appreciated..

Thanks guys!

[Chuck Bole]

I think that ch 12 is limiting your throttle. Would need to see your servo monitor screen..
Check out this video.. Helped me get mine lined out..

Graupner/SJ MZ-24 Heli throttle setup (4 min 33 sec)

[JasonA]

WOW! that did it! thank you so much!! I spent 3 hrs screwing around and searching for vids and that one didn't pop up

DV1 was the culprit! disabled it and now have full 100% throttle!

Thank you again for this! now let's see how the rest goes!

[JasonA]

Initial flight flew great..figured out the qlinks for the idle up and throttle hold.. did a test auto in the driveway

So far so go.. just need to figure out the gyro gain switch stuff but I hardly ever mess with that once a heli is flying good.