Throttle Range settings after ESC enpoints?

[nyawton]

I have successfully gone through the gpro setup, setting all travel adjust to make everything hit 100% as the guide says.

Next step was to set up the Esc (a castle talon 90)

To do this following the guide I had to change the throttle travel adjust on my controller then slowly increase until the talon beeped.

Now it all appears to be working, all inputs look good, motor works as expected.

But now in the gpro software the throttle is not hitting 100% because of said change for the esc.

Do I ignore, or have I gone wrong somewhere? Thank you.

[nyawton]

Anyone? Really got me stuck this one :-(

Sent from my E6653 using Tapatalk

[TR450ZS]

As with any other FBI, ignore it, set the travel so the esc works properly and enjoy.