Fun, Learning, Friendship and Mutual Respect START  HERE


Unregistered
Go Back   HeliFreak > R/C Helicopter Support > 470 Class Electric Helicopters



Reply
 
Thread Tools Display Modes
Old 01-05-2017, 12:46 PM   #1
Memphis3
Registered Users
 
Posts: 84
 

Join Date: Jan 2017
Location: South
Question 470L Drive Gear Mount & Bearing Shaft

My 470Lm kit had a tight main shaft. Had to grind down the ID a little to fit and may have taken off a little to much.

470L Drive Gear Mount H47G002XX$12.99
470L One-way Bearing Shaft H47G005XX $3.99

These look to be the same or similar and can you disassemble the Drive Gear Mount and install One-way Bearing Shaft
Memphis3 is offline        Reply With Quote
Old 01-06-2017, 03:53 AM   #2
Andy from Sandy
Registered Users
 

Join Date: Dec 2006
Location: Bedfordshire, UK
Default

It will all come apart. It could well have been assembled with retaining adhesive so you will need to use heat and maybe a press or vice to get it all apart.

I would of been inclined to of polished down the main shaft with some oil and wet and dry paper with it spinning in a drill.
Andy from Sandy is offline        Reply With Quote
Old 01-06-2017, 08:43 PM   #3
kevindnyc
Registered Users
 
Posts: 201
 

Join Date: Jul 2015
Location: NYC
Default

My main shaft was also tight when rotated, just found that the bearing below the autorotation bearing is seized up. Going to contact align trex store

D420, Align 470, Align 450pro v2
kevindnyc is online now        Reply With Quote
Reply




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Copyright © 2004-2016 by RCGroups.com, LLC except where otherwise indicated. The HeliFreak.com logo is a trademark of RCGroups.com, LLC.