Fun, Learning, Friendship and Mutual Respect START  HERE


Unregistered
Go Back   HeliFreak > R/C Helicopter Support > Beam


Beam Beam Helicopters Factory Support Forum


Reply
 
Thread Tools Display Modes
Old 09-14-2014, 11:12 PM   #1
Rotosmasher
Registered Users
 
Posts: 43
 

Join Date: Jun 2011
Location: South Australia
Default V2 (2013) Autorotation bearing fitment.

I have both V2 and V2 (2013) bearings, cases and sleeves. The V2 fits fine as per original bearing. The V2 (2013) bearing protrudes beyond the bearing case and makes it impossible to fit through the gap in the frame with the pulley and sleeve assembled. It also means that the main gear wont align with the pinion. Has the lower mainshaft bearing block been changed? Any hints or tips? My heli is a V1.
__________________
You are only as good as your next crash.
Rotosmasher is offline        Reply With Quote
Old 09-15-2014, 01:33 AM   #2
RasmusDK
Registered Users
 
Posts: 641
 

Join Date: Nov 2008
Location: Denmark
Default

It only fit the v2 frame, it has a cut so it can go straight in
RasmusDK is offline        Reply With Quote
Reply




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Copyright © 2004-2016 by RCGroups.com, LLC except where otherwise indicated. The HeliFreak.com logo is a trademark of RCGroups.com, LLC.