Screw set for T-Rex rebuild - HeliFreak
Fun, Learning, Friendship and Mutual Respect START  HERE

Go Back   HeliFreak > R/C Helicopter Support > 500 Class Electric Helicopters > 500 Pro Class Electric Helicopters

500 Pro Class Electric Helicopters 500 Pro Class Electric Helicopters manufactured by Align, Tarot, SYMA, Airhog, Chaos, HK and similar.

Thread Tools Display Modes
Old 10-30-2016, 05:06 PM   #1
Registered Users
Posts: 76
My HF Map location
Join Date: Sep 2008
Default Screw set for T-Rex rebuild

Hi Guy's, I have been out of the heli's for three or so years, concentrating on fpv quads and planks, but I now have the time to start back on my heli's again. First thing I have done is go through each one and see what needs doing before putting back up. I have found that my two 500 pro's need to be pulled down and have a freshen up. One needs a new battom plate and landing gear, and the other needs at least a new tail rotor shaft as it is slightyy bent. So I have found a few of the screws ar not shifting and stripped the heads, I will get them out ok, but I am looking at putting a stainless screw kit in both of them to avoid same prob next time. Question being has anybody have recomendations on a particular kit or are they pretty much all ok??
neale is offline        Reply With Quote
Old 11-20-2016, 09:22 PM   #2
Registered Users

Join Date: Nov 2010
Location: Burlington Ontario

I find some stainless screws strip easier then the regular ones. I got an extra screw set when I ordered some other parts. Replace the ones that need it and your good to go.
700 Goblin, Trex 500 PRO DFC, 300X, 180CFX, MCPX Nano QX - 2 DX8's JR dbl TX case.
CrashCanuck is online now        Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Copyright © 2004-2016 by, LLC except where otherwise indicated. The logo is a trademark of, LLC.