EZOSD Setup

[WyDiablo]

I"m about to order an EZOSD very soon and I was looking at the installation instructions. The one thing that caught my eye was where they show to plug in the "ESC". Can someone explain what I"m suppose to plug into that connector (Brain fart here)? I take it that I"m suppose to run a "+ & -" wire from one of the esc's to this plugin correct.? Here is the EZOSD installation sheet.

[setishock]

Actually it goes between the battery and the power distribution board or harness to measure voltage and current being consumed.

[WyDiablo]

So then I could come off the battery connectors and into the esc connector on the ezosd to make that connection correct?

[daneger21]

My distribution board "+/-" plugs into the "esc +/-" on the current sensor. Then my flight battery plugs into "battery".

[xpantz]

Originally Posted by WyDiablo

So then I could come off the battery connectors and into the esc connector on the ezosd to make that connection correct?

Plug your battery in where is says "battery"

then take power to all your ESCs (any anything else that's using that battery) either via a PDB or a loom from the "ESC" connector.

So you want to take all power from the "ESC" connector on the current sensor... so you know your total power usage.

It would probably be better if they relabled "ESC" "power out"

[WyDiablo]

Thanks for the help guys

[WyDiablo]

I found this easy installation video just in case someone needs the know how to install the OSD. But most folks don't have brain farts like myself lmaoooo.

Demonstration of how easy it is to connect your EzOSD up to your FPV system from FirstPersonView.co.uk! (3 min 36 sec)