Register Now

Bluemoose · 03-08-2017, 09:42 PM

Is there any reason that the Pitch and the Throttle would be reversed on the 14sg? Everything else works flawless other than the two channels being reversed. I am using the 14sg as the master and the 18mz as the slave. But I don't think that should pose an issue.
Throttle on the 18mz runs the pitch on the 14sg and Pitch on the 18mz runs the Throttle. Just a little strange to me. any suggestions?

Costas · 03-09-2017, 03:42 AM

Check your channel assignments - There is no reason that the two transmitters should be different.

Bluemoose · 03-09-2017, 01:57 PM

OK so if the 18mz is set up as the Master it works fine. With the 14sg as the, master the pitch and the throttle are reversed. It' is driving me absolutely nuts. The reason that I need the 14 as the master is because my instructor is having to move fairly fast and I would like to have the 14 dialed in. Any help or thoughts would be a great help.

Mike Padron · 03-09-2017, 02:48 PM

The fix for using the 14SG as Master and 18MZ as Slave is to change the Throttle to CH5 and Pitch to CH3 in the 18MZ function page.

Go figure...

Aloha!

Mike

03-08-2017, 09:42 PM	#1 (permalink)
Bluemoose Registered Users Join Date: Feb 2016	Futaba 18mz Slave 14sg Master Trainer Is there any reason that the Pitch and the Throttle would be reversed on the 14sg? Everything else works flawless other than the two channels being reversed. I am using the 14sg as the master and the 18mz as the slave. But I don't think that should pose an issue. Throttle on the 18mz runs the pitch on the 14sg and Pitch on the 18mz runs the Throttle. Just a little strange to me. any suggestions?

03-09-2017, 01:57 PM	#3 (permalink)
Bluemoose Registered Users Thread Starter Join Date: Feb 2016	I agree OK so if the 18mz is set up as the Master it works fine. With the 14sg as the, master the pitch and the throttle are reversed. It' is driving me absolutely nuts. The reason that I need the 14 as the master is because my instructor is having to move fairly fast and I would like to have the 14 dialed in. Any help or thoughts would be a great help.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-09-2017, 03:42 AM	#2 (permalink)
Costas Registered Users Join Date: Jul 2007	Check your channel assignments - There is no reason that the two transmitters should be different.

03-09-2017, 02:48 PM	#4 (permalink)
Mike Padron Registered Users Join Date: Mar 2015 Location: Scottsdale, AZ	The fix for using the 14SG as Master and 18MZ as Slave is to change the Throttle to CH5 and Pitch to CH3 in the 18MZ function page. Go figure... Aloha! Mike

Register Now

Log-in