START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
450 Aftermarket Upgrades 450 Aftermarket Upgrades |
|
LinkBack | Thread Tools | Display Modes |
10-25-2011, 04:32 AM | #41 (permalink) | |
Registered Users
|
Quote:
The flanged bearings go together nicely into the KDE links and don't bind at all, even after the Allen screw is snugged up properly on the tail rotor grips. When I first installed it, the slider would bind. Under magnification it could be seen how the links weren't lining up with the gap in the slider where the link and brass bushing is supposed to fit. If you look really closely at the link, the link isn't symmetrical. The side that bolts to the tail rotor blade grip (and has the flanged bearings) is slightly higher than the side that screws onto the slider (and has the brass bushing). If the link is installed "upside down", the parts will not align properly and will bind. So if yours binds, then try flipping the link the other way around. The "higher" side of the link should be against the blade grip, and not against the head of the Allen bolt. With the link properly oriented, you should be able to snug up the screw and bolt normally and nothing should bind. Hope this helps.
__________________
Custom quad copter, Cobra C-3525/18 motors and ESCs; APC 15x4 thin electric props. OpenPilot ControlCopter board. Futaba 8FG Super 2.4 gHz FAAST system. |
|
Sponsored Links | |||
Advertisement |
|
10-27-2011, 09:22 AM | #42 (permalink) |
Registered Users
|
Does anyone have a part number for the Align aluminum slider bearing holder?
The stock slider bearing holder is plastic with a steel insert to hold the ball link. Thanks in advance for any feedback. Bill |
12-13-2011, 07:14 PM | #43 (permalink) |
Registered Users
Join Date: Aug 2011
|
Do u hv video showing the correct installation for this upgrade?.....and 1 more thing, is it ok (has anyone try it yet?) to install this upgrade and at same time flipping the 450 pro grip?....waiting to install mine.
__________________
All begins (Jun 2011)....... Next project: MSH Mini Protos, 450 Scale Airwolf, BAH Mini Quad |
04-01-2017, 10:56 PM | #44 (permalink) |
Registered Users
Join Date: Feb 2017
|
tail binding issue solution for stock or upgrade tails
I have been focusing on eliminating all the o-rings and brass bushing entirely on my heli. I have yet to fly my heli, but I guarantee it is solid and smooth. All you need is a reliable set of vernier calipers and get measurements of your ID and OD from bushings, then go to fasteddy to get a bearing to fit your needs. Whether it's factory or aftermarket, BUSHINGS SUCK.
http://www.fasteddybearings.com PS, it hasn't flown because I haven't received new Tx yet is all. |
Thread Tools | |
Display Modes | |
|
|