receiver to FC

[rhsmd]

i just got a nighthawk 280 pro, and the FC is based on the NAZE32.
i am going to use a spectrum receiver, 6 channel.
when i hook up the 8 pin connector from the board to the receiver, the first plug has 3 wires, and the rest have 1 wire.
my question is on the receiver the first plug slot is labeled throttle.
in the manual, the order on slots for the receiver is and,+5v, ail,ele,thr,rud,aux1, aux 2.
do i just plug them in straight across as the receiver is labeled, or do i put the specific wires to the plugs, in the order the diagram?
thanks guys

[KSHeli]

The 3 wire plug provides + and ground to the rx then just plug the rest occurring to the channels of your rx, the single wires are the signal wires for each channel. So yes plug the single wires according to your rx mapping.