X5 tail problem.

[Thespius]

Hello helifreak's.I have this heli on the self collecting dust 2 years and i decide to give it a try.I remove my Vbar and i put BeastX.I did the set up and when i spool it up my tail wants to go right(nose left) in high speed.
I change my tail blades with a little bigger than stock(84mm),and i put on it a BeastX.These were the changes i made.Before these changes i fly it once (2 years before) and all were good.Sry for my bad english.
I try to raise my gain but nothing changed.

[tonys-heli]

make sure after the setup, you chose the right tail compensation.
also make sure your rudder is going the right direction for the correct inputs.
right rudder makes the slider go towards the boom.

[mverhorst]

Originally Posted by tonys-heli

make sure after the setup, you chose the right tail compensation.
also make sure your rudder is going the right direction for the correct inputs.
right rudder makes the slider go towards the boom.

+1, check your compensation and inputs.

[nflanagin]

And your in Heading Hold mode

[DanMcN]

During intitalization you should see your heading hold light about L to start. In rate mode make tail blades are about 0 degrees. Travel +- is set.

[Thespius]

Thank you all.I check it when I will buy battery.My last battery died.And I will not buy a new one soon.