Problem with Communication with the Tribunus

[Philip Coccari]

So I just got the Tribunus 200 amp esc and its a beauty! I also got the new VLink 2 cable. Here is what I did. I am running this system with a VBar Neo and a VControl Radio. I have downloaded the Scorpion software. I run it as administrator. I have the Tribunus installed and hooked up to the Neo via the throttle channel to the Master on the Tribunus. I have the VLink cable hooked up to the laptop. I get the tones that it is linked. I get two red lights on the VLink controller. I have the VControl radio on. I hook up the battery to the heli. I get the morse code from the tribunus. When I hit search on the software, it cannot find the tribunus. I have tried this on two computers. I am stumped!! Any suggestions would be appreciated. Thanks!!

[shadco]

.

You need the software bundle with the USB driver included install the driver

Diaper cable in the pic port in the esc with yellow wire on the diopter towards the red battery cable on the esc.

Vlink cable attached to the diopter cable and plugged into the pc you should hear a tone when you plug it in.

Start software and search for connection.

Watch the bobby watts video.

Set the esc fo vbar pid and communications.

[robertvizzo]

if you didn't plug in the diode cable with the usb vlink the vlink is trash. You will need to get a new one. I did this and had to borrow a friends vlink cable.