Faulty Aomway commander goggles?

[aburn09]

Can anyone with the new Aomway Commander goggles confirm wether I have a faulty set ?
With mine everything seems to work ok but when I press button 2 for 3 seconds to go into DVR mode the 'rec' symbol shows in the top right corner of the screen pressing button 2 briefly it starts flashing and recording pressing briefly stops recording........... but the 'rec' symbol stays in the corner and doesn't disappear so from now on until I disconnect the battery the 'rec' stays in the corner ? I assumed pressing button 2 again would disable DVD mode so removing the 'rec' symbol but all it does is make the picture go wavey ?
Do I have a fault or does anyone elses do this ?

[aburn09]

Someone has been kind enough to answer my question on another forum the answer was as below :-


dovcharov
This is normal. REC label does not dissapear until you turn off the goggles.
As for pictures becoming wavey - you turn on the DVR in the background, so the waves you see is actually DVR menu covered by video feed overlay. To make DVR menu clearly visible you need to press and hold left 5-pos joystik for 3 seconds. Then radio feed gets cut off, and you'll see the DVR.

Today
#468
aburn09
Thanks Dovcharov I understand now I was switching on the DVD menu when I pressed button 2 for a another 3 seconds without pressing button 3 for 5 seconds first ......When I press the correct buttons now in the correct sequence ie 3 first to bring up the playback screen 'then' button 2 which brings up the menu all makes sense and explains the wavey lines i was getting ........unfortunately the instructions weren't clear enough for me to understand but now I do thanks to your help.
It's a shame you can't turn off the 'rec' symbol though when your not recording so you have a clear screen for flying ?

[aburn09]

A copy to the link where these goggles and my question were being discussed......


https://www.rcgroups.com/forums/show...2#post37551651