START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
FMA/Revolectrix Product Support FMA/Revolectrix Factory Product Support |
|
LinkBack | Thread Tools | Display Modes |
08-14-2017, 05:41 PM | #1 (permalink) |
Registered Users
Join Date: Jan 2012
|
Blown Fuses on MPA Board
As the title says, so how how do I change them out? They seem to be soldered in
Sent from my iPhone using Tapatalk |
Sponsored Links | |||
Advertisement |
|
08-15-2017, 06:54 AM | #2 (permalink) |
Registered Users
Join Date: Sep 2015
|
Easiest method is to use solder wick to remove the solder, then fuse is easily replaced.
Fyi - they are soldered because none of the fuse holders can handle 40A without significant voltage which affects charging accuracy. |
08-15-2017, 01:34 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Jan 2012
|
Thank you. Do you if there's a particular type of 40 amp blade fuse I should get?
Sent from my iPhone using Tapatalk |
08-15-2017, 01:56 PM | #4 (permalink) |
Registered Users
Join Date: Jun 2012
|
When replacing fuses, carefully break the plastic off. This will allow removal of one fuse blade at a time. Less heat to the board. Then wick excess solder.
__________________
Diabolo 700, Oxy 5 Nitro, OMP M2, Futaba |
08-15-2017, 07:01 PM | #6 (permalink) |
Registered Users
Thread Starter
Join Date: Jan 2012
|
Does anybody know what spec fuse I need? I found these on Amazon.
Sent from my iPhone using Tapatalk |
Thread Tools | |
Display Modes | |
|
|