CB180D Help

[Jgaspar]

Hi guys, I'm new to to this hobby.

Just need some help.

My brother recently broke the aluminum CNC rotor head. I have already replaced it with a new one, and I also understood that when I change the rotor head, I would need to do a bit of fine tuning mechanically to have a stable flight.

However, after a short while of test flight. My heli went out of control on ground, smoke was observed (but not sure where) and the rotors were spinning but the transmitter was off! I pulled out the battery then.

Now whenever I try to plug in the battery, the rotors will spin almost at full torque, while the transmitter is off.

Has my RX2423 been short circuited? Do i need to replace it or....??? Please help.

Thanks.
Jeff.

[N3M0]

Check your trims on your throttle make sure they are all the way down. Also if you can, try to bind with another transmitter. That will let you know if its the transmitter or the reciever.

[varmit]

hi.. Smoked my receiver a few months ago. mine was caused also by a crash.