receiver type selection

[helichef]

I'm using a .Jeti DS 16 radio and R7 plus receiver I'm trying to set up my spirit system on my heli.On the spirit set up page under receiver set up I'm a bit confused which receiver type am I using?It lists many not sure which one to select.Need help

[dogbreath]

You'll likely use EX Bus, and you'll have a split pin as shown in the online manual for the hookup to the Spirit. In device manager, you set your E1 or E2 (or EXT if not a REX receiver) to EX Bus protocol and that's where you'll plug in the wire that goes to the Spirit.

edit: I see it's an R7, not a REX7, so plug into the EXT port set to EX Bus.

Dan

[dogbreath]

Just to the right of the receiver selection there's a CHANNELS button. It will show you the order you want to use when setting the transmitter SERVO ASSIGNMENT. You'll play with sticks etc and make sure movement is where you expect it. If not, you're transmitter is not set up in the same order as the Spirit is expecting. You can also activate the throttle channel if you're going to plug the ESC into the Spirit.

Dan