START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
bavarianDEMON/HeliCommand Factory Sponsored Bavarian DEMON and HeliCommand Support |
|
LinkBack | Thread Tools | Display Modes |
03-22-2017, 01:24 PM | #1 (permalink) |
Registered Users
Join Date: Jun 2010
|
Setup issues
I received a hd500 with the 3z. I have done other units, but all I get is a hot mess of servos going all over the place. Can't even get remotely close.
HD500 Kontronik ESC 3x BD MKS 9767 I installed the iKon 2 and mostly set up in less than 10 minutes and servos are all operating correctly.
__________________
Trex 700L Ikon 2 / Trex 700L Ikon V. 2 / SAB Goblin 500 Sport Ikon 2 / HD Cell 500 Ikon 2 It isn't about if, it is about when! |
Sponsored Links | |||
Advertisement |
|
03-22-2017, 03:42 PM | #2 (permalink) |
Registered Users
Join Date: Dec 2016
|
after powering up, how long does it take the servo's to start acting up?
Sounds like an ESC issue, or compatibility issue. I had one similar do this and my problem was the ESC. Let us know how everything turns out, or keep us updated. Dennis |
03-22-2017, 09:33 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Jun 2010
|
Don't think so, working fine with iKon
__________________
Trex 700L Ikon 2 / Trex 700L Ikon V. 2 / SAB Goblin 500 Sport Ikon 2 / HD Cell 500 Ikon 2 It isn't about if, it is about when! |
03-24-2017, 06:18 AM | #4 (permalink) |
Registered Users
Join Date: Dec 2010
|
What exactly do the servos do when acting up? All the time? Or only at stick movements?
More details would be helpful.
__________________
Joachim CAPTRON Electronic GmbH - bavarianDEMON Support, Product & Sales Manager - |
03-24-2017, 10:15 AM | #5 (permalink) |
Registered Users
Thread Starter
Join Date: Jun 2010
|
Whenever I move the sticks, other than rudder, nothing corresponds with stick movements. Also cannot reverse pitch.
__________________
Trex 700L Ikon 2 / Trex 700L Ikon V. 2 / SAB Goblin 500 Sport Ikon 2 / HD Cell 500 Ikon 2 It isn't about if, it is about when! |
03-24-2017, 11:07 AM | #6 (permalink) |
Registered Users
Join Date: Jan 2011
|
Connect to the computer and clear all the previous settings start from scratch... Go through the complete setup including Tx.
__________________
Helicopters Don't Fly - They Beat The Air Into Submission Logo 500SE Minicopter Diabolo 700 Banshee # 45 700 LE and 850 |
03-24-2017, 01:04 PM | #7 (permalink) |
Registered Users
Thread Starter
Join Date: Jun 2010
|
Did that as one of the first things I tried.
__________________
Trex 700L Ikon 2 / Trex 700L Ikon V. 2 / SAB Goblin 500 Sport Ikon 2 / HD Cell 500 Ikon 2 It isn't about if, it is about when! |
04-04-2017, 09:46 AM | #8 (permalink) |
Registered Users
Join Date: Dec 2010
|
Any news here? Did you get it to work by now?
If not, some ideas: So all signals in the Diagnose are as expected? Push Ail stick to the right, does the Diagnose's Ail bar go right too? Is this the case for all controls and directions? If that is all set correct, then proceed with the swash setup and servo reverse to get all servos work correct for collective first. Once this is ok, check Ail and Elev swash movement. In case, use any axis reverse needed. Now all should be fine. Oh, and make sure the swash mixer in the radio is at H1 / single servo. Nothing else allowed in the radio!
__________________
Joachim CAPTRON Electronic GmbH - bavarianDEMON Support, Product & Sales Manager - |
04-04-2017, 01:05 PM | #9 (permalink) |
Registered Users
Thread Starter
Join Date: Jun 2010
|
I finally gave up on it and put the iKon 2 on it'. I may try and mess with it later. Nothing I did made it work.
__________________
Trex 700L Ikon 2 / Trex 700L Ikon V. 2 / SAB Goblin 500 Sport Ikon 2 / HD Cell 500 Ikon 2 It isn't about if, it is about when! |
04-05-2017, 03:22 AM | #10 (permalink) |
Registered Users
Join Date: Dec 2010
|
If you want, you are welcome to send the system to Danny, our US distributor. He could check it on a heli and either confirm the issue resulting from the unit, or confirm a well working unit. This would help for sure.
If you want to do this, get in touch with Danny (F1 Rocket here on the forum).
__________________
Joachim CAPTRON Electronic GmbH - bavarianDEMON Support, Product & Sales Manager - |
04-05-2017, 01:27 PM | #11 (permalink) | |
Registered Users
Thread Starter
Join Date: Jun 2010
|
Quote:
__________________
Trex 700L Ikon 2 / Trex 700L Ikon V. 2 / SAB Goblin 500 Sport Ikon 2 / HD Cell 500 Ikon 2 It isn't about if, it is about when! |
|
Thread Tools | |
Display Modes | |
|
|