Gaui Governor / Jeti set up help please

[guyguerra]

Hi, I have installed a Gaui governor on my NX7. I get the green light to show that it's on, and I can get it to work on my normal mode. I can post the Jeti screen shots if needed. I set the normal throttle curve with a 3 piont curve, piont one at 0, then piont 2 at 20-50 and 100-50. Basically a 50% flat line with a ramp up from 0. I set idle one at 70% constant and idle 2 at 90% flat. Ithe governor will kick in, but it won't change when I change my switch. It also won't come back to normal so I have to land with 2000 head speed.

In the Jeti radio I turned the Governor on in the Basic screen, and went into the Governor menu and set my flight mode switch to 50%, 70% and 90% to match my throttle curves. I'm not even sure the governor should be turned on in the Jeti radio.

I called Esprit but they aren't familiar with nitro governors. Can someone tell me how to set up the Jeti radio, or if something else is wrong?

I have the governor turned on and off by the Throttle Hold switch. James at Esprit had me change port 1 on my R3 receiver to be assigned to the governor. i am using a Demon BD3SX.