Naza M Lite Won't Configure

[Dave Willis]

I've searched all weekend and am unable to find an answer to my Problem
Naza M Lite
Futaba 14SG Radio
I was finally able to get Windows 10 to Download Drivers
LED Plugged into LED Port
USB Cable has been changed
RX Bound to TX
When Powered up in Assistant, Assistant is Reading the MC, Green Light is on and the Blue Light is Flickering. But it will not Configure.
I get a Pop Up Box that says Configuration Error. Hope this fix won't be as difficult as the Drivers.

I've fooled with this thing all weekend, Sure will appreciate any Help in getting this thing figured out.
If this has been covered before , I apologize for posting again. I couldn't find it

Thanks in Advance......Dave

[04fxdwgi]

Try this:

To downgrade back to 1.00 lite firmware, you need to connect F1 and F2 ports with any servo cable, connect to USB and power on your Naza, start Naza LITE Assistant, go to upgrade page and confirm upgrading to 1.00. After upgrade disconnect F1 and F2 connection, power cycle your Naza. Now you have default Naza-m lite firmware

[Dave Willis]

Firmware I had Downloaded was 1.0 but I did as you instructed, No Change

Thanks for your Help.....Dave

[Skapr1]

Originally Posted by Dave Willis

"I've searched all weekend and am unable to find an answer to my Problem..............it will not Configure.
I get a Pop Up Box that says Configuration Error".

From the NAZA M LITE faq page:
http://www.dji.com/naza-m-lite/faq

How to deal with the configuration error?
Please calibrate your transmitter sticks and then restart MC.

Just a shot in the dark but maybe this will help solve your problem!