vortex vx1e on rush 750?

[em3jefferson]

are any of you using the Spartan vx1e on your rush 750? if so what numbers are you using for your main and tail gains? thanks

[crashcopterman]

I have a VX1n on mine, settings should transfer over, providing you are on the same firmware version. I'm on 4.02. Tail on mine may differ though, I have an Evo with the higher tail ratio.

Evo with Rail 716's and 106's

Main
N=50
1=50
2=50

Tail
N=45
1=45
2=45

See a trend here? I've only changed agility and style from the wizard, gains were very good as is.

Cheers

Steve

[Michaelinpr]

+1 for default settings. V4.02 and up are great on these numbers. May find you only have to go up or done a few points to get that last tuning in. On the Rush I always had to run a fairly high collective to tail precomp. Default is 8 or so. I have been up at 35. Depends a bit on tail gear ratio and head speed. Point is, defaults work very well

[Rsams]

I know im a little late on this post but here are my settings with KBDD 710 mains and 115 tails and 2200 head speed.
Main rotor;

N-50 (only use for hovering so it's stock f3c setting)
1-45
2-30
I-32
P-37
Feed forward - 7
D elevator - 75
D aileron - 7

Tail:

N - 45
1 - 45
2 - 31
CW stop - 90
CCW stop - 60
P - 27
I - 58
D - 0

Hope this helps. I'm sure the more flights I put on mine the more those may change.