Msrx tilts to the leftnanf front hard when I try to take off.

[floydian70]

I got a used Msrx and it flew slow. Even with my rates and expo at 100/inh. I tried to lower the front of the swash plate by adjusting the control arms. Now no matter what I do it will only go left right. Is there a way to calibrate the drift or anything?

[JonJet]

From out-of-the-box swash settings, extend the left servo rod 2 full turns...

Shorten the front servo rod one full turn...

This is a good beginning...with a little fine adjustment, it will take off and hover hands-free for a short time...and left or right piro should be simple and smooth

But be careful...the stock swashplate is very easy to break !

[floydian70]

Actually got it in a hover but it fly's like the rates are low and I have them all set "100% inh". Which is why I started messing with it in the first place. I have my trims and sub trims all the way to one side so I still have some tweaking to do. At first I thought it was not having a flybar for awahile but its just too unresponsive. Also my board goes out sometimes when I throttle. Then eventually it will catch. Thanks for your advice.

[JonJet]

That sounds like more of an electrical issue...

Check the wires where they connect to the board, and inspect the pins inside the battery connector to be sure they are straight...

Also, the mSRX does not like any trims or subtrims...they act as swash inputs and may be the source of your slow performance issues

[floydian70]

Comes straight up nice etc. Trims are centered and no sub trims. She comes up perfect but its like fwd and left seem like high rates but when I want to go backwards or right it seems like the rates are low. My rates n expo are 100% inh for all channels. Help!!!!!!