Cyclic issues with mini vbar on my 50

[jph140]

Hi everyone, I've just tried to get my mini vbar working on my fusion. I've followed all the instructions to the exact. The tranny is set to 1 servo 90 degrees, I've gone through the setup carefully up to where you need to make sure all the servos travel in the right direction. I can get the collective to move and down as it should but I cannot get the cyclis to work correctly. No matter what I reverse in the vbar software nothing works and I'm pulling my hair out.

Any advice gratefully recieved

Cheers

[Slyster]

You probably make a very common mistake.. one I did too... and that is you need to unplug and physically reverse ch2 and ch3 on the miniv. Carefully look at the servo channels in setup mode on your screen to see which channel goes to which servo... do not follow the manual as that is one example setup.

[Carapau]

+1

Forget the manuals, just swap servos in their channels and/or reverse servos until it works as it should. I never looked at the manuals and just swapped and changed until I got it right. Easy and works a treat.

[jph140]

All sorted guys, had the elevator channel in channel 2 and not 1. Feel a right T*t

Thank you all for replying :-)