Removing Tail blades rocker - HeliFreak
Fun, Learning, Friendship and Mutual Respect START  HERE

Go Back   HeliFreak > R/C Helicopter Support > Walkera Helicopters > 4G6 / V120 Series

4G6 / V120 Series Walkera 4G6 / V120 Series Helicopter Support

Thread Tools Display Modes
Old 01-13-2010, 08:55 AM   #1
Registered Users

Join Date: Jan 2010
Location: The Netherlands
Default Removing Tail blades rocker

I cannot figure out how to remove the tail blades rocker from the tail gear assembly.
It is secured by a pin and i am trying to push that pin upwards with a small needle from the underside but that does not work.

Any ideas?
Snuggles is offline        Reply With Quote
Old 01-13-2010, 09:02 AM   #2
Registered Users
Posts: 4,890

Join Date: Jan 2009
Location: Columbia MO USA

The pin is tapered try the other end.
Gaui Hurricane w/ 530mm blades & Robird G31
Walkera Super CP
Walkera Devo 10 w/ Deviation
SQRT(-2) is offline        Reply With Quote
Old 01-13-2010, 02:20 PM   #3
Registered Users
Posts: 2,233

Join Date: Jan 2007
Location: Cheektowaga NY

it is?! i must have gotten lucky then. mine slid right in.
cx2, mcx, T Rex 450 SA, GAUI 550, walkera cb100, 4#6, 4#6S, 4g6S, trex 450 clone, V911/FP100, DX7, DX8
never hold your farts in. they travel up your spine, and that's where s****y ideas come from.
shaggybirdman is offline        Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Copyright © 2004-2016 by, LLC except where otherwise indicated. The logo is a trademark of, LLC.