CYPHER HEAD SET UP~LINKAGE meassurements - HeliFreak
Fun, Learning, Friendship and Mutual Respect START  HERE

Go Back   HeliFreak > R/C Helicopter Support > Other Makes and Models Helicopters > Cypher 3D

Cypher 3D EF Cypher 3D

Thread Tools Display Modes
Old 05-08-2010, 11:09 AM   #1
Registered Users
Posts: 1,376
My HF Map location
Join Date: Mar 2010
Location: Dudley, MA. U.S.A.
Default CYPHER HEAD SET UP~LINKAGE meassurements

When setting up your head adjust the links as needed so that:

-Servo arms are horizontal
-Swash plate is level
-Washout mixer arms are level
-Fly bar arms are level
-Main blades have zero degrees pitch

This should be done when both sticks are centered on your radio and with your pitch curve setup for zero degrees at mid stick.

The above will give you push rod lengths of:

-Blade grips to fly bar mixing arms = 18mm
-Fly bar mixing arms to swash plate = 40mm
-Fly bar arms to washout mixer arms = 24mm
-Swash plate to front-left and front-right servo arms = 33mm
-Swash plate to rear servo arm = 29mm

There is a photo of the Cypher's head at zero degrees on page 3 of this PDF:
it's not a competition, it's a hobby
EXI 450 + FUTABA t7c Tx =
Phoenix Sim "it's free to crash on a sim"

Last edited by kevinbattista; 05-09-2010 at 12:25 PM..
kevinbattista is offline        Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Copyright © 2004-2016 by, LLC except where otherwise indicated. The logo is a trademark of, LLC.