START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
R/C Helicopter Tools and Supplies Tools and Products used with R/C Helicopters |
|
LinkBack | Thread Tools | Display Modes |
05-08-2012, 03:08 AM | #1 (permalink) |
Registered Users
|
How to connect 2 power supply from 12V to 24V
I have just got 2 server power supply's, Astec IBM AA23260, and I've solder the pins together so that I got 12V out, but do anyone know how to wire the supply's to get 24V, is there just to remove the ground from the outer case? and wire them in series?
Do anyone know this? Raptor 50 T-Rex 500 Comet 500 Sepektrum DX7 Last edited by Helieik; 05-08-2012 at 07:10 AM.. |
Sponsored Links | |||
Advertisement |
|
05-15-2012, 11:45 AM | #2 (permalink) |
Registered Users
|
Check out this link.
http://www.rcgroups.com/forums/showt...1164359&page=2 I followed the directions in the attached link to wire two similar power supplies together. Note that these power supplies are from a different manufacture so some things may be different, but if you have a general knowledge of power supplies, you should be able to figure it out. |
Tags |
from 12v to 24v |
Thread Tools | |
Display Modes | |
|
|