problem with quaser

[rob221]

Im having a problem. With my quaser it wont supply enough power to run my rjx servos they move very slowly. If at all have no problems. If I swap out to 1 of my a turnigy units. Any ideas have had this unit for over a year purchased from gryphone mall. Realy want to getting this unit operating properly before I replacee the turnigy units in 3other nitros had an inflight failet with one. So lost confidance in the turnigy unit

[RasmusDK]

It sounds very strange that it cant supply enough power.

Are you sure this is the problem?

Which fbl system do you use?
Some systems do slow speed down when sitting on ground and do stick input

[rob221]

Originally Posted by RasmusDK

It sounds very strange that it cant supply enough power.

Are you sure this is the problem?

Which fbl system do you use?
Some systems do slow speed down when sitting on ground and do stick input

Its running an illness as mentioned precviously works fine wheni change
To one offf my turnigy units with same setup and settings

[rob221]

Its running an ikon and work s as xpected when using a turnigy on same settings

[mverhorst]

Do you have a way to measure the output voltage of the BEC under load?

[kthane]

Uhh, you can't run a quasar on anything less than a 3 cell lipo. Just thought I would throw that in there.