Register Now

STiRider · 06-27-2018, 07:42 AM

Hi
I need help with mb+ governor. I have a trex 470lm with stock align rce-bl50x ESC, stock motor and mb plus 4.2 version. My problem is that, when I use gov on beastx, (ESC gov disabled) and set the slow rump up speed (on beastx parameter menu) below 300rps, my motor start and stops 3-4 times until it finally spools up. On 300rps and above, spools ok. Anyone has a clue of why this happens?

Orby · 07-03-2018, 03:15 PM

I lost a lot of time with your own configuration without ever being able to make the governor work.
the only configuration that worked decently is (for me):
Esc with softstart
Remove the softstart with studio x in MB (after that, do not change the sploolup anymore in studio x)
Play, play, play with endpoint on tx.
pay attention to the failsafe of MB
Orby

06-27-2018, 07:42 AM	#1 (permalink)
STiRider Registered Users Join Date: Apr 2018	Microbeast plus spool up problem Hi I need help with mb+ governor. I have a trex 470lm with stock align rce-bl50x ESC, stock motor and mb plus 4.2 version. My problem is that, when I use gov on beastx, (ESC gov disabled) and set the slow rump up speed (on beastx parameter menu) below 300rps, my motor start and stops 3-4 times until it finally spools up. On 300rps and above, spools ok. Anyone has a clue of why this happens?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-03-2018, 03:15 PM	#2 (permalink)
Orby Registered Users Join Date: Nov 2017	I lost a lot of time with your own configuration without ever being able to make the governor work. the only configuration that worked decently is (for me): Esc with softstart Remove the softstart with studio x in MB (after that, do not change the sploolup anymore in studio x) Play, play, play with endpoint on tx. pay attention to the failsafe of MB Orby

Register Now

Log-in