Sab 500 taill kicks when switching banks.

[alibaloch94]

Hello folks


Heli flies fine,

No tail kicking during pitch pumps or anything

But when i go from idle up 1 to idle up2, there is a very significant tail kick.

It was not there before, it came after I rebuilt this heli

Nothing was changed, same pulleys, every thing same.

[xoexoe]

What FBL?

Is your head speed changing too quickly?

[ticedoff8]

It was not there before, it came after I rebuilt this heli

Something changed in the FBL controller.
Tail comp, tail gain, ESC gain, RPM ramp-up - etc, etc, etc.

[motoxxxman]

Was anything done that could have altered the tail neutral point?
I would suggest setting up your TV to have a switch that changes the gyro mode from heading hold to rate mode. Take off like you normally would in HH mode, get into a stable hover a bit off the ground and plenty of space around the heli, and flick it into rate mode for a moment and then back to HH mode. Watch what the tail does in rate mode. The heli should not rotate, or should only rotate a very small amount very slowly. If it spins around with any amount of speed, the tail servo pushrod and/or servo neutral point needs to be adjusted.
Improper tail neutral setting can cause some funky stuff