![]() |
START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Flybarless Helicopter Systems CSM Cyclock, Helitronix Multi-mixer, Spartan AP2000i, Firmtronix Digimix-3, Gyrobot, SK360and AC3X |
![]() |
|
LinkBack | Thread Tools | Display Modes |
![]() |
#1 (permalink) |
Registered Users
Join Date: Jun 2013
|
![]() Trying to setup the ZYX S2 gyro. The setup s/w servo monitor reflects input from TX. Trim setup moves the servos. Travel set to 100. Wrote to flash before disconnect USB to PC. Reboot the gyro get solid blue light but unable to get response from servo when moving the TX sticks. Any idea why? I have two of these unit and both does the same.. Thanks..
|
![]() |
![]() ![]() ![]() ![]() |
Sponsored Links | |||
Advertisement |
|
![]() |
#2 (permalink) |
Registered Users
Join Date: Mar 2015
Location: Germany / Nuremberg
|
![]() What cyclic and tail servos are installed in the heli? What are their specs?
What digital servo settings are you using in the ZYX? AFAIK the digital/digtal setting sends 333Hz to the tail and 333 / 3 = 111Hz on the cyclic. Your cyclic servos are digital, right? ![]() What heli are you mounting the ZYX S2 onto? Did you have any further luck in the past months?
__________________
Walkera Devo 10/DeviationTX (12CH DSMx & telemetry)...Ex-DX8...Blade 4503D...Walkera V120D02s...XK K110...Blade 200QX quad...Ex-NanoCPX...Ex-120SR...StrykerQ (LEDs, M2 tuning)...Ex-MPX EGP...PPZ P51-D...PZ Wildcat (searching fuselage-firewall) |
![]() |
![]() ![]() ![]() ![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|