Align Esc setup with Vtouch

[Elgreco]

Hey guys, Getting back into it after a long time and I have an old 550 trex with align electronics on it
and I am looking for someone to point me to a thread that I can read how to setup the esc with the radio tho old Fashion way

My newer heli ,I got the vlink and telemetry which is honestly a breeze.

But on this older one I have, since the electronics are already there, I Just need to setup the TX
I've done the swash and all but I need to setup the Esc and Speeds.

I don't remember anything, LOL on how to setup the Esc with sticks and all
if you could point me somewhere that would the great!

Thanks

[Elgreco]

Sorry for a duplicate post ( main discussion)but I think I might get help here faster

Hey guys, Getting back into it after a long time and I have an old 550 trex with align electronics on it
and I am looking for someone to point me to a thread that I can read how to setup the esc with the radio the old Fashion way

My newer heli ,I got the vlink and telemetry which is honestly a breeze.

But on this older one I have, since the electronics are already there, I Just need to setup the TX
I've done the swash and all but I need to setup the Esc and Speeds.

I don't remember anything, LOL on how to setup the Esc with sticks and all.How to get to programming, and whether the Vtouch would be the same in the way of programming it like my old JR
if you could point me somewhere that would the great!

Thanks

[Elgreco]

I am trying to setup an old Trex 550 I have that I got a vbar satellite to use with a mini vbar and my touch radio.

I am trying to program the ESC that is on it (Align electronics) but how do you enter setup mode (Assuming it is still powering on with full stick)
because by the time the radio connects to the vbar automatically , it won't go into setup mode.

Any clarification on how to do this as I am still fairly new to Vtouch.

My other heli I have the vlink (so simple) but this one I am clueless.

I have managed to do the swash and switch assignments and I think now I have to setup ESC and throttle curves etc.

Any information on how to proceed with this part of the setup and how to configure if necessary governor (or simply estimate speeds for the banks) would be great.

I did a test flight today (since it was spooling up )and it was on a very low speed , no different speeds on the banks, simply needing further setup.

I am returning from a long time away from the hobby so sorry for any stupid questions.

Thanks

[Skiddz]

Please do not cross post. Your threads have been merged.

[Vinger]

You just go to the heli setup and throttle endpoints under governor setup, keep the page open and power cycle the mini VBar with the collective stick in the upper position, and it should enter setup mode.